VIFLY WhoopStor 3 V3 6 Ports 1S Battery Storage Charger Discharger for FPV Tinywhoop 4.2V 4.35V BT2.0 PH2.0

VIFLY WhoopStor 3 V3 6 Ports 1S Battery Storage Charger Discharger for FPV Tinywhoop 4.2V 4.35V BT2.0 PH2.0

What's new of WhoopStor 3?

1. Increase the maximum charge current from 0.9A to 1.3A charges much faster especially for large capacity batteries like 850mah.

2. Open the tooling for the case around no exposed parts any more.

3. Change to a colorful LED screen each cell current also can be displayed.

4. Add the fan and big heatsink for heat dissipating the discharging efficiency improves a lot.

5. Add the buzzer to beep when the charging circle finishes.

6. Add the feature of remembering the last current setting no need to set the current each time.

7. Support 6S battery input.

8. Remove all switches all operations are through the two buttons that is much easier

V2 New Version with adding real BT2.0 connectors.

Storage Charger and Discharger with OLED Display

 

VIFLY WhoopStor is the first 1S whoop battery charger with storage. Besides charging the battery to full voltage it can start the charger or discharger automatically to get your battery into storage voltage. The charging status is displayed clearly on the OLED screen like the battery voltage charge current etc.

 

6 Individual Ports PH2.0 and BT2.0 Compatible

 

VIFLY WhoopStor can charge 6 batteries at the same time. These are 6 individual charging channels not charging parallel but rather individually you don't have to worry about making sure the batteries are all the same voltage and same size. It is compatible with both PH 2.0 and BT 2.0 connectors and you can mix charge BT2.0 and PH2.0 battery at the same time.

 

Type-C XT60 and DC Input

 

VIFLY WhoopStor supports Type-C XT60 and DC power input. Type-C used PD and QC protocol that supports fast charge at 9V and 12V but it not supports regular 5V USB charge.

 

Regular and HV Battery Supported

 

VIFLY WhoopStor 1S charger supports both regular battery at 4.2V and high voltage battery at 4.35V. You can switch it easily with the button.

 

Heat Sink to Cool the Unit

 

The big heat sink below the PCB board would effectively dissipate the heat to prevent the unit from overheating when charging or discharging.

 

Dimensions:	101*49*22mm
Input connector:	XT60 DC(5.5*2.1mm)
	USB-C(PD3.0 QC2.0 BC1.2)
Input voltage range:	7V-21V (XT60 2S-5S Battery DC)
	9V / 12V (USB-C)
Max input power:	30W
Max charging current:	0.9A/port
Support battery connector:	PH2.0 & BT2.0
Battery type:	LiHV 4.35V (±0.05V) / LiPO 4.2V(±0.05V)
Storage voltage:	3.85V(±0.05V)
Max discharge power:	1W/port

 

"

The post Shop appeared first on ABC_toy.

from Shop - ABC_toy https://ift.tt/70qOpg6
via IFTTT